MIT · core >=0.1.0-beta.1 · sink · linux_amd64, linux_arm64, darwin_arm64, windows_amd64 · 7955.4 KB · Nov 17, 2026
Bed Mesh shows the mesh bed leveling map of your printer (MK4/MK4S, MK3.5, MK3.9, Core One, XL, MINI) on its page in Prusa Connect Local: a heatmap seen from above, a 3D surface you can turn, the range from the lowest to the highest point, and a history of every mesh you save, with a point-by-point comparison between any two.
How to use it. Open a printer and choose the Bed Mesh tab.
Measure: heat the bed, make sure it is clear, and choose Run mesh bed leveling. Prusa Connect sends the printer G28 and G29.
Read the mesh: plug the printer into your computer with a USB cable and choose Read over USB (Chrome or Edge, with Connect opened over HTTPS or on localhost). Or send
M420 Vfrom any serial console (Pronterface, or a terminal at 115200 baud) and paste what the printer printed.Save: add a note, such as the sheet or what you changed, and choose Save to history. Open any saved mesh, or compare against it to see how far every point moved.
Why the USB step. The printer keeps the measured mesh in its memory and, for now, prints it only on its USB port. Over Prusa Connect it acknowledges G-code but sends no output back, and its telemetry carries no mesh. We have asked Prusa to send the mesh to Connect: Prusa-Firmware-Buddy#5626. When the firmware does, Bed Mesh will read it automatically and the USB step goes away.
Full manual: https://github.com/HonzaJaros/connect-bed-mesh/blob/main/docs/MANUAL.md
New in 0.1.5: the same extension as 0.1.4, built from a repository that no longer carries a key pair committed there by mistake (it was never used to sign anything). Since 0.1.4 the tab explains the USB step and links the manual.